TCP/WebSocket API
  • Getting Started
  • Information and Preferences
    • Get Device Information
    • Request Device Configuration
    • Configure Device Configuration
    • Request Accessory Names
    • Configure Accessory Names
  • Accessory Controls
    • Outlets
    • Nightlight
    • Color Light - HSV
    • Color Light - Temperature
  • Fetch Accessory Status
    • Outlets
    • Nightlight
    • Color Light
    • Sensors
  • Synchronous Updates
    • Outlets
    • Nightlight
    • Sensors
  • OTA
    • Request Available Updates
    • Perform OTA Update
    • OTA Download Progress (Synchronous)
    • OTA Result Update (Synchronous)
  • Device Management
    • InvisOutlet
      • Restart InvisOutlet
      • Reset InvisOutlet's Network Settings
      • Factory Reset InvisOutlet
      • Check MQTT Status
      • Home Assistant Discovery
    • InvisDeco
      • Restart InvisDeco
      • Reset InvisDeco
      • Occupancy Sensor Calibration
      • Temperature and Relative Humidity Calibration
  • API Reference
    • Terminology
Powered by GitBook
On this page
  1. OTA

OTA Result Update (Synchronous)

[InvisOutlet -> TCP/WebSocket]

Updating device's OTA firmware download progress.

Response

  • sn: The serial number of the InvisOutlet.

  • packetID: Represents the ID of the packet based on request packetID.

  • payload:

    • callbackName : 23

    • callbackArgs :

      • 1 : 1 - InvisOutlet, 2 - InvisDeco, 3 - InvisOutlet (WWW partition)

      • 2 : Whether the OTA is performed successfully or not (except InvisOutlet WWW partition update); 1 - Device will reboot immediately, 0 - Fail

{
    "sn": "0003D44076",
    "packetID": 301552,
    "payload": {
        "callbackName": 23,
        "callbackArgs": [
            1,
            1
        ]
    }
}
PreviousOTA Download Progress (Synchronous)NextDevice Management

Last updated 1 year ago